99.9 percent sure I am going to rip my own strips. Would like a recommendation on a good thin kerf blade, where to buy, and how much they run. Also, has anyone had good/bad experiences with this process: I will be walking off strips with circular hand saw.
Who I am precedes what I do, not the other way around.
To answer your question, I bought a thin kerf blade from Menards. I don't know what brand. It was many years ago (15?) and was about $25.
The first canoe I made I used the walking-off-strips-with-circular-hand-saw technique, and I found that it worked very well. I actually prefered it to using a table saw ... at least until you get down to the last few inches of width.
The worst part of cutting the strips for me was the tedium. The first couple of dozen was OK, then it got old. I think my estimate was 70 full length strips. However, I was not using full length strips so I was cutting over 100.
Also, if possible set up outside. I think it is more enjoyable, but even more, you have better ventilation and easier clean up.
I think mine was a Freud, cost about $40 or so. As usual, I'm in agreement with Bannock. Cut the strips outside or somewhere with a lot of ventilation and consider wearing a mask or respirator, cedar creates just a ton of dust.
BTW Cedar and Ash (sanding dust) are both reputed to be toxic when inhaled. A dust mask is cheap insurance and definitely do this outside! I just ripped all the strips for my Freedom17 and there was a PILE of dust even with a thin kerf Freud.
Purchasing pre-milled strips for me is too pricey. I'm a ripper!
Help keep support this community and website with the many resources it provides and maintains.
Learn more
We use cookies to enhance your experience, for analytics, and to support 3rd party content and advertising providers. If you continue using this website, you agree to our privacy and legal agreement.
Ok